Aiwa Z-L520 Operating Instructions Manual page 14

MULTI
JOG
2
a
8,10
<< >>
1,10
In the programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
OTE
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
7 Insert the tape into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
"PRGM EDIT" and "PRGM" are displayed.
PRGM PRGM EDIT
lf "Al" is displayed, press CD EDIT/CHECK while pressing
SHIFT again.
4 Press numbered buttons 0-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
¢ << | > or MULTI JOG are also available to designate
the tape length.
Tape side A (front side)
Tape length
Maximum recording time for side A
5 Press one of DISC DIRECT PLAY 1-3 to select a
disc. Then, press numbered buttons 0-9 and +10
on the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then +10 and 0.
Selected disc Program
number
Remaining Programmed
number time on side A track numbers
Selected track number
14 ENGLISH
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B (reverse side)
8 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side A and press
@REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
deck 2 enters the recording stop mode. After entering the
recording stop mode, go to step 9.
9 Press CD EDIT/CHECK while pressing SHIFT on
the remote control for recording of the second
side.
"B" is displayed.
10 Turn over the tape in Deck 2 and press @REC/
REC MUTE to start recording.
Recording starts.
To stop recording
Press ll. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press <4 or
»P repeatedly.
Track number Programmed track numbers
Disc number
Program number
To change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B, and press EICLEAR to clear the
program on.the selected side. Then program tracks again.
To clear the edit program
Press HICLEAR twice in stop mode so that "EDIT" disappears
on the display.
¢ Recording is inhibited if the erasure prevention tab on either
side of the tape facing out from the unit is broken off.
¢ Up to 30 tracks can be programmed from any of the inserted
discs.
¢"FULL' is displayed if you attempt to program more than 30
tracks.