Sharp YO-250M Service Manual page 7

<For English version>
Notes:
© To interrupt data transfer, press [ON].
'Notes:
© To interrupt data transfer, press [ON].
Notes:
© To interrupt data transfer, press [ON].
Notes:
Notes:
* Tointerrupt data transfer, press [ON].
Notes:
pear. Press to clear the error.
ZQ-2500SP
<For English version>
1. Select the mode on the transmitter and receiver.
* Press [C-CE] . (Transmitter)
¢ Press [SCHEDULE]. (Receiver)
2. Press [MENU], then 2 ("OPTION"), the data transfer func-
tion on the receiver.
3. Press 2 ("RECEIVE") to set the unit in the receive mode.
<UNIT TO UNIT>
RECEIVING
MODE
4. Press [MENU], then 2 ("OPTION"), the data transfer func-
tion on the transmitter.
Note: To transfer a single entry display the desired entry and
press 2.
5. Select 1 ("SEND") to transfer data.
1
Notes:
© If the mode of the transmitter and the mode of the receiver are not
the same, data transfer is not established. The message "DATA
ERROR' is displayed. When transferring TEL data, directories on
the transmitter and receiver can be different. The contents
received by the receiver wilt be stored in the open directory. For
example, if TEL 1 is selected on the transmitter and TEL 3 on the
receiver before the data transfer is established, the contents of
TEL 1 will be sent to and stored in TEL 3.
© Turn off the SECRET function on both the transmitter and the
receiver before mode transfer.
© {f the amount of memory available on the receiver at the time of
transfer is insufficient, data transfer is not possible. The message
"MEMORY FULL" appears. Delete any unnecessay data, verify
whether the available memory is sufficient, and repeat the data
transfer procedure.
© {fan error message appears while transferring data, press
to clear the error.
Transferring backup data
All the contents of the Organizer are transferred. During backup data
transfer, data stored on the receiver is deleted. Proceedwith caution.
(Backup data transfer is only possible between identicalmodels.)
1. To select the data transfer function on the receiver and set it in the
receive mode for backup data transfer, press [MENU 2
<UNIT TO UNIT>
BACKLJP
RECEV ING
MoD E
2. To select the data transfer function on the transmitte aand perform
backup data transfer, press [MENU] [v] 2 1%,
Verifying data
It is possible to verify data by mode or by mode 01 entry. If any
discrepancies are found, the message "VERIFY EFROR" is dis-
played.
Verify data in the SCHEDULE mode.
1. Select the mode on the transmitter and the receiver,
¢ Press [SCHEDULE] then [C-CE]. (Transmitter)
e Press | SCHEDULE |. (Receiver)
2. Set the receiver in the verify mode.
Press |} MENU], then 2 to set the receiver in they erify mode.
<UNIT 1) UNIT>
~VERIy ING-
fto sn e mn At aN