Option Programming - CrimeStopper CS-2000DPII Series IV Installation & Operating Instructions Manual

1. Turn the Ignition ON and press the Override/Program button 5 times. After a slight delay, the system will chirp and
flash the lights 5 times.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren and horn will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, quickly press the appropriate button on the remote control according to
the chart below. Button 1 gives a single light flash / chirp, Button 2 gives two light flashes / chirps, and Buttons (1+2)
together gives three light flashes / chirps.
4. Turn Ignition off. System chirps and flashes the lights 3 times on exit. When you are finished customizing options,
check operation.
PROGRAMMING OPTIONS CHART
Option # Option Description
1. Factory Horn Chirps Pulses
Passive Arming /
2.
Passive Chirp Countdown
3.
4. Ignition controlled Locks
5. 5/60 Sec. Door Open Warning
6.
7. Double Unlock Pulse
Silent Arm/Disarm
8.
(Chirp Defeat w/Button 1)
9. Parking Lights on with disarm
10. Disarm with trunk pop
Silent Arm/Disarm with Remote
11.
12. Door Lock Pulse Time
13. Type of Carjack Protection
14.
Carjack Features Enable/Disable
15.
L/UL or Arm/Disarm w/IGN ON
Dataport Protocol 1-Way = OFA,
16.

OPTION PROGRAMMING

Passive Lock
Active Re-Arm
(Button #2)
2-Way = SL
* = Default Settings
BUTTON 1 BUTTON 2
Lock Unlock Trunk Aux #1
Pulse with trip Arm Disarm Chirps
only & Pulse with trip
ON *OFF*
ON *OFF*
*ON * OFF
5 Sec. *60 Sec.*
*Enabled * Disable
*Disabled * Enable
*Disabled * Enable
*Enabled * Disable
Disable *Enabled*
*Enabled * Disable
*0.75 Sec.* 3 Sec.
*Active * Active & Passive
*Disabled * Enable
*Lock/Unlock * Arm/Disarm
*2-Way* 1-Way
8
BUTTONS (1+2)
TOGETHER
*Arm Disarm Warn Chirp &
Pulse with trip *
Passive Arm with
Chirp Countdown
Custom Override
Ignition Lock Only
Full-Time