Cleaning Drive Disc And Driven Disc; Drive Spring Repair/Replacement; Driven Disc Adjustment - Snapper 16 Series Safety Instructions And Operator's Manual

Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
USE
\
\
4.3 DRIVEN DISC SERVICE
If the mower does not propel itself properly, See
Figure 4.6. Check for the following problems:
DRIVEN DISC &
RUBBER RING POLY-V
i
i DRIVE
ENGINE'
DRIVE
BELT
DRIVE
DISC
FIGURE 4.6
FIGURE 4.7
4.3.3. DRIVEN DISC ADJUSTMENT
If the drive disc and driven disc are clean and the
mower drive is sti slipping, adjust the driven disc as
follows:
1. Place ground speed control in the number six
speed position. See Figure 4.8.
1. Grease on drive disc causing slippage.
SPEED CONTROL
TO
SIX SPEED POSITION (ROPE START MOUNTED ON
2. Broken or disconnected drive spring, rll! F HiNDLE)
3. Driven disc is out of adjustment. /. RIGHTSIDEO
4. Driven disc rubber ring is worn - does not contact f/ ...........
drive disc properly.
"
S XTH SPEED
5. Worn Poly-V Belt or engine drive belt.
_ POSITION
)
SIXTH!
NOTE: If any of the above (1 thru 5) are causing
problems, service as follows:
4.3.1. Cleaning Drive Disc & Driven Disc.
If oil or grease on the drive disc or driven disc is
causing slippage, clean discs as follows:
1. Wipe away any oil or grease with a clean cloth.
2. Use either an approved grease solvent or hot .............
soapy water to clean drive disc or driven disc.
3. Rinse components with clean water.
4. Dry components with a clean cloth.
4.3.2. Drive Spring Repair/Replacement
If drive spring is loose, reconnect as shown in Figure
4.7. If spring is broken, replace with new spring.
FIGURE 4.8
IMPORTANT: If machine drive system continues
slipping see Trouble Shooting section.
13