Lenovo ThinkSystem SR950 V3 System Configuration Manual page 61

See "Troubleshooting by system LEDs and diagnostics display" on page 29
LED indications.
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
•
https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
5. Back up the server configuration.
6. Install the applications and programs for which the server is intended to be used.
55.
for more information on the
Chapter 5
.
Chapter 4 Unboxing and setup
53