Recalling The Memories - Vertex Standard VXA-150 Operating Manual

When the desired first character appears, press
the CHANNEL selector knob momentarily to
move on to the next character.
r Select succeeding characters in the same man-
ner, pressing the CHANNEL selector knob mo-
mentarily after each selection.
r After entering the entire name (eight characters
maximum), press the [ MW ( SPL.W )] key for 2
seconds to save all data for the channel and exit.
Note: If you have stored a Weather Channel, the
"WX - 001~ WX - 010" labels utilize the alphanu-
meric memory, and other labels may not be stored.
Advice: The entire Memory Storage procedure, de-
scribed above, is subject to a five-second "time-out"
timer. If you wait more than five seconds after any
key press or control function, the entire Memory Stor-
age process times-out, and you will have to start over.
Alpha-tag Charactors
0 1 2 3 4 5
C D E F G H
O P Q R S T
-
< > + Û
VXA-150 P V O
RO PERATING
M
EMORY
6 7 8 9 A B
I J K L M N
U V W X Y Z
D µ S | -
/
M
ANUAL
O
PERATION

Recalling the Memories

r Press the CHANNEL selector knob, repeatedly
if necessary, until "MR" (Memory Recall) ap-
pears on the display. In the MR mode, you will
see "CH - " and the previously selected channel
number appearing on the LCD.
r Rotate the CHANNEL selector knob to select
the desired memory channel.
r You may change the title structure of the Memory
display type among:
1. Channel Indication (sequential Channel Number,
e.g. CH - 001, CH - 002, etc.);
2. Frequency Indication (e.g. 122.500); or
3. Alphanumeric Label (e.g. LAX FSS).
r To change the Memory display title, press the
[ ( )] key repeatedly, if necessary, until you
get the desired display title structure.
r To exit the Memory mode, press the CHANNEL se-
lector knob momentarily to return to the VFO mode.
Note: In the "Book" Memory mode, you can change
memory channels in 10 channel steps: press the [ F ]
key momentarily, then rotate the CHANNEL selec-
tor knob. The " " icon will show at the right edge
of the display when the 10 channel step tuning mode
is active. Press the [ F ] key once more to resume nor-
mal channel selection in 1 channel steps.
23