Advertisement
UseonlyBUSSELL Styb 8 RepHacement BeHts ( #3200)Un
0
Jnp_ugcleaner trom elemncal ou!le_
With Rotating F!oor Brush remove(] from vacuum cleaner
(Steps 1-5 of Check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove flom Motor Pulley. Discard
old Drive Belt
Place new Drive Belt over Motor Pulle ana s_re_cnother end
over Rotating Floor Brush in the space aelween tne arts-lies.
Place ends of Rotating Floor Brush down into slots on sides
as shown,
O_urn
Rotating Floor Brush by nana several cm_esm _ne
d rection of Motor Pulley, if properly installed, Drive Belt will
center itself on Rotatrng Brush crown,
Reeosition Brush Cover and screws. Tighten screws secure y.
UseonlyBISSELL Replacement B ulb _#203o1007)in
_Unp[ug
c_eanerfrom electrical outlet.
@Rernove
OetacbaNe Car Bieraria rec _neuana_eof vacuum.
Jsing a screwanver, remove _neone screw as ShOWn anc
lift off the ens.
Remove the bulb from the socket oy pusnmg in gently and
turning it towards brush. Install the ;ew bulb by pushing it
gently into _neSOCKet and turmng away from brush.
@ Reposit!on lens and secure with the one screw.
Select _ledels Only
If theTurboBrush stopsrotatingor will no1pick up
debt& checkfor a clog,It a clogis present,unscrew
the two screwsin the back ofthe TurboBrush to remove
the faceplate,Clearany obstructionsreassemble and
replacethe two screws,
@
Advertisement
