Advertisement
AV-28WFT1EPG
AV-28WFT1EIS
AV-28WFT1EPS
AV-32WFT1EPG
AV-28WFT1EKS
AV-32WFT1EPS
AV-28WFT1EK
AV-32WFT1EKS
. Receive a cross-hatch signal.
re Select 7.TRAPEZ with the FUNCTION UP/DOWN key.
30. Press the MENU key and memorize the set value.
Measuring
L
.
Z
Test point
Adjustment part
instrument
Adjustment
Signal
of TRAPEZ
generator
Remote
control unit
Parallel
=
Lf
—
8.EW. COR. L
9.EW. COR. H
. Select 8.EW. COR. L with the FUNCTION UP / DOWN key.
36. Adjust EW. COR. H, and bring the straight line at the upper
corner.
. Press the MENU key and memorize the set value.
Adjustment of
EW. COR. L/H
Signal
generator
Remote
control unit
Straight
Straight
Adjustment
of V-S.CR &
V.LINE
When
the vertical
linearity has been
deteriorated
remarkably,
perform the following steps.
38. Receive a cross-hatch signal.
39. Select 11.V-LIN with the FUNCTION UP/DOWN key.
41. Select 10.V-S.COR with the FUNCTION UP / DOWN key.
42. Set the initial setting value of 10.V-S.COR with the FUNCTION
-/+ key.
43. Adjust 11.V-LIN and 10.V-S.COR so that the spaces of each
line on TOP, CENTER and BOTTOM
become uniform.
11. V-LIN
NOTE :Do not adjust "PANORAMIC" & "16 : 9 ZOOM SUBTITLE"
mode.
*
For JK chassis
On
account
of
CRT
(ITC),
set
V-S.COR
except
for
"PANORAMIC" mode to the minimum.
When
adjusting "PANORAMIC"
mode,
slightly expand the
space
at the CENTER
while taking
the circularity at the
CENTER into consideration.
eee
eee
ee
fa
eC
_
Advertisement
