Advertisement
AV-28WFT1EPG
AV-28WFT1EIS
AV-28WFT1EPS
AV-32WFT1EPG
AV-28WFT1EKS
AV-32WFTIEPS
AV-28WFT1EK
AV-32WFTIEKS
IF CIRCUIT ADJUSTMENT
Adjustment of | Remote
control unit
Under normal conditions, no adjustment is required.
. Receive any broadcast.
. Select 1.IF from the SERVICE MENU.
. Check
the characters
colour
of the JUST
REFERENCE
displayed to yellow.
won
- @
VCO(CW) **.
MHZ
TOO HIGH
ABOVE REFERENCE
JUST REFERENCE
BELOW REFERENCE
TOO LOW
@: ext
i=
VSM PRESET ADJUST SETTING
Measuring | Test point
Adjustment part
Description
instrument
Setting of
Remote
. BRIGHT
.
Select 5.VSM PRESET from the SERVICE MENU.
VSM PRESET
|control unit
. CONT.
.
Select COOL with the MENU key of the remote control unit.
. COLOUR
.
Adjust the FUNCTION UP/DOWN and -/+ key to bring the set
. SHARP
values of 1.BRIGHT
~
7.B DRIVE to the values shown in the
. HUE
table.
. R DRIVE
.
Press the MENU key and memorize the set value.
. B DRIVE
.
Respectively select the VSM PRESET mode for NORMAL
and WARM, and make similar adjustment as in 3 above.
Press the MENU key and memorize the set value.
* Refer to OPERATING
INSTRUCTIONS
for the PICTURE
MODE.
VSM preset mode
COOL
NORMAL
Setting item
SETTING VALUE
Pee
[= [= [=
SETTING VALUES OF VSM PRESET
22
~ No. 51694
Advertisement
