Assembling The Stand - Sanyo LCE-22A100F Service Manual

Assembling the Stand

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to
mount your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure
of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or
improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can
cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Locating grooves
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.
To install the stand:
Locators
1. Remove the stand from the box and place it on a table or bench.
2. Lay your TV flat (screen down) on the edge of a table or bench. Make
3. Insert the stand column into the stand socket, move the column
screws
Stand
To remove the stand from the TV, perform these steps in reverse order.
You must pay attention to the direction of the stand. The wide portion
of the stand should go towards the front of the TV.
sure that you put down a soft cushion or cloth so that your TV is not
scratched.
steadily until the Locators on the column align with the locating
grooves on the stand. And align the holes in the stand with the holes
in the stand column, then secure the stand to the column with
screws(provided).