Sanyo LCE-32R83DT Service Manual page 49

If the stand is provided, please read these instructions thoroughly before attempting this installation.
S
afety Precautions:
1.Please read these instructions thoroughly prior to attempting this installation.
2.Be sure to handle this product very carefully when attempting assembly. If you are unsure of your
capability, or the use of tools necessary to complete this activity, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to
mishandling or improper assembly/installation.
3.When using a table or bench as an aid to assembly, be sure to put a soft cushion or covering to prevent
accidental scratching or damage to the unit's finish.
4.The speaker is not intended to support the weight of this display. Do not move or handle this product
from the speaker; which can cause damage to the display not covered under the manufacturer's
warranty.
To install the stand:
1. Remove the stand from the box and place it on a table or bench.
You must pay attention to the direction of the stand. The wide portion of the stand should go towards
the front of the TV.
2. Lay your TV flat (screen down) on the edge of a table or bench. Make sure that you put down a soft
cushion or cloth so that your TV is not scratched.
3. Attach the stand column to the back of the TV, align the holes in the TV back with the holes in the stand
column, then secure the stand column to the TV with the screws provided.
4. Align the stand to the stand column, align the holes in the stand column with the holes in the stand, then
secure the stand to the stand column with the screws provided.
NOTE:
1.Appearance of this product in illustrations may differ from your actual product, and is for comparative
purposes only.
2.Design of this accessory or display products are subject to change without notice.
Appendix: Installing the Stand
Secure with
three screws (T4x10BT)
Stand column
S ecure with
one screw (T4x14BT)
Stand