JVC PC-X110 Manual page 16

PC-X110 B/E/G/GI/EN
© Seek tuning
Press the UP or DOWN button for one second or more;
the unit enters the seek tuning mode and tunes to
higher or lower frequencies, and when the broadcast is
received, it stops tuning automatically and the broadcast
can be heard.
In AM operation, the frequency moves continuously from
the MW to the LW band and vice versa.
© Manual tuning
Each time the UP or DOWN button is pressed, the unit
steps through the current frequency band. Tuning is in
steps of 50 kHz for FM and 9 kHz for AM(MW/LW).
In AM operation, the frequency moves continuously from
the MW (522 - 1,629 kHz) to the LW (144 - 288 KHz) band
and vice versa.
Press to move to lower frequencies
Notes:
© When seek tuning to the required station is not possible
because it is broadcasting too weak a signal, press the
UP or DOWN button momentarily to perform manual
tuning.
© When the power is set to STANDBY, or another mode
(TAPE or CD) is selected, the last tuned frequency is
stored in memory. When the power is switched on again
and TUNER/BAND button is pressed, the same station
will be heard.
ve stations (using the remote control
unit)
15 stations in each band (FM and AM (MW/LW)) can be
preset as follows:
© Example (when presetting an FM station broadcasting
at 103.5 MHz to preset button "15")
Press the TUNER/BAND button.
Select the FM band using the TUNER/BAND button.
Tune to the required station.
Press preset button "+10", then "5" for more than 2 sec.
(When "15" blinks in the preset station display, the
station has been preset.)
Repeat the above procedure for each of the other
stations, using a different preset button each time.
Repeat the above procedure for the AM(MW/LW) band.
© Tochange preset stations
Perform step @ above after tuning to the required
station.
16 (No. 1904)
DOWN-TUNING-UP
Press to move to higher frequencies
Auto preset tuning
This function scans the current band (FM or AM(MW/LW)),
detecting frequencies used to broadcast signals, and stores
the first 15 frequencies in memory automatically.
© Press the AUTO PRESET button for more than 2
seconds. The frequencies of stations broadcasting
signals can be preset automatically in the order of
increasing frequency. (15 stations in each band (FM
and AM(MWILW.)))
Notes:
© The previous preset station is erased when a new
Station is set as the new station's frequency replaces
the previous frequency in memory.
'© When listening to an AM(MWILW) broadcast, noise may
be heard if the remote control is used.