Advertisement
Tuner
CD player
SYNCHRO CORD
Cassette Deck
LINE OUT
Important!
The illustrated power plugs are intended for
general reference. The power plug used in your
country may differ from the illustration. (Exam-
ple: U.K., Australia, U.S.A., Europe etc.)
To household AC outlet
A SPEAKER L
©
O pity
Left channel
speaker system
SPEAKERS terminals
Be sure to connect the:
+ wires to the + terminals (red);
— wires to the — terminals (black);
How to connect the speakers
Strip off a 1cm length of vinyl covering from
the end of the speaker cord.
Loosen the Red and Black speaker terminals
by turning them counter-clockwise. (These
terminals cannot be removed.)
0
Q
8
4)
Turn the terminals clockwise to securely
fasten the cords.
IMPORTANT: Do not cross connect speaker sys-
tems. Use either the A terminals or B terminals for a
pair of speakers. Do not connect one speaker to an
A terminal and the other to a B terminal.
On the required speaker impedance
When using one pair of speakers:
Turn one of the A or
B SPEAKERS
switches to
on. Connect speakers of 6 to 16 ohms imped-
ance.
:
When using two pairs of speakers:
Turn both the A and
B SPEAKERS
switches to
on. Connect speakers of 12 to 16 ohms imped-
ance.
Refer to the markings on the amplifier's rear panel.
Power cord
Connect this cord to the Akai tuner's SWITCHED
AC OUTLET or directly to a household AC outlet.
On the PROCESSOR IN/OUT and G.E. REC jacks
This Akai amplifier is equipped with special PROC-
ESSOR jacks for connection to a graphic equalizer
or audio processor.
Remove the pins of these jacks only when connect-
ing one of these accessories and keep them ina
safe place. Do not lose these pins. Refer to page
12.
DIGITAL OUT COAXIAL jack
Connect the DAT deck's DIGITAL INPUT jacks or a
D/A converter which has a digital interface circuit.
Connection can be made with a coaxial PIN-piug
cord such as a video connection cabie available in
most Hi-Fi stores. Refer to page 1 3.
Advertisement
