F-
aan
Se
OO
a aay
itit
I
=
LS EL
fe
E A
m
mn
p
ha
fe iM
Recording
operations
Pos
a
mmnn
mn an a
=p
Cha
"eal
- CA
E
eel
ROTS621
|
Recording from radio broadcasts |
Wind up the leader tape so recording can begin immediately.
1
Press [ DECK 2 OPEN} and insert the tape.
Close the holder by hand.
A
TETT
only
Press [REV MODE] to select the reverse mode.
Every time you press the button:
BD
a OP
td
->
FE
: One side, only, records.
2>,C2>
: Both sides record (front side -> reverse side).
sc) " automatically changes to "=>" when [@REC/STOP]
is pressed.
3| Select a radio station. Perform steps El through
on page 12.
4
Press [@ REC/STOP] to start recording.
To stop recording
Press [@ REC/STOP] again.
Recording can also be stopped by pressing [HB].
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part while recording
1. Press [(@ REC/STOP] during the unnecessary part. The cassette
deck will go into the stop mode.
2. Press [(@ REC/STOP] to resume recording again. Recording will
continue in the same direction as before.
To start recording on the reverse side
Load a tape and change the tape direction as follows:
1. Press [TAPE, DECK 1/2] and select tape deck 2.
2. Press (@/II) and immediately thereafter [Æ]. The tape direction
will be shown as "<".
To record on the other side of the tape
Tum the tape over and press [® REC/STOP}.
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
py
To reduce noise while AM recording (Beat proof
function)
Press [</<<4, FM MODE/SP] while recording.
Each time you press the button, "BP1" and "BP2" will be displayed
alternately.
Select the position where there is less noise.