GE JGBP30 Owner's Manual & Installation Instructions page 47

re.corn
Possible Causes What To Do
Display goes blank A fuse in your home may be • Replace tile fuse or reset tile circuit breakex:
(onsome models) blown or the circuit
breaker tripped.
The clock is turned off so that it • See the Using the clock and timersecfi()u.
does not show in the display.
Display flashes Power failure. • Reset the x'l(>ck.
(on some models)
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at
displayto show "SF" not touched properly, the same time and held fi)x 3 seconds.
(on some models)
Power outage, Power outage or surge. • Reset the clock./f the oven was in use, you must l'eset
clock flashes it by touching the CLEAR/OFFpad, .settiu_ the clock and
(onsome models) resetting any x()()king tuux'ti(m.
"Burning" or "oily" odor This is normal in a new oven • To speed the process, set a sell=clean cycle fi)r a
emitting from the vent
and _11 disappear in time. minim um of 3 hotus.
See the Using the self-cleaning
oven section.
Strong odor An odor from the hlsulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan may automatically • This is uoxanal. The coolin,_ tim will ttu'u off and on.
tttnl on and off to cool
internal parts.
Drawer does not slide The drawer is out of aligmnent. • Fully extend the drawer and push it all the way in.
smoothly or drags See the Care and cleaning of the range secfi_m.
Drawer is over-loaded or load • Reduce weight. Redistribute drawer
x-()nteuts.
is unbalanced.
47
o_
o_
_iiiiiiiiii}iiii _
iIiiii i