GE JGBP30 Owner's Manual & Installation Instructions page 43

Installation instructions
[] iNSTALLiNG THE ANTI-TIP
DEVICE
A WARNING!
• Range_ must be secured with an approxed Anti-Tip
device.
• Unless properly installed, the range could be tipped
bx _ou or a child standing, sittino or leaning on an
open dooi;
• Mter instnlling the Mlt.i-Ti I) device, xerif_, that it is in
place b) careflflly attempting to tilt fl_e range fiwward.
• This range has been designed to meet all recognized
industry tip stnndards fi_r all nmmal conditions.
• The use of this device does not prechMe tili) )in,,_ of
the range when not properly installed.
• If the Anti-Tip dexice stq_plied with the range does
not fit this application, use the tmixe_sal Anti-Tip
device _ B2X7909.
A, Mark the wall where the RIGHT EDGE _ff the range
is to be located. Be sine to allow for the counte_o 1)
overhang if you intend to install the range next to
cabinets,
SIo_ed head
screw
Approx. 28
Marked edge of range
B. Locate the outside edge of the device 9¼" toward
the center of the range fl'om the marked edge of
the range.
C. Llsing the device as a template, mark the position of
the hole fbr the screw.
D. For x_ood construction, drill a pilot hole at ,an ,'m,,le
of 20 degrees from the horizontal. A nail or awl
max be used if a drill is not available.
Motmt the Anti-Tip device Mth the screw pr(Mded.
For cement or concrete construction, you will need
a 1/4" x 1½" lag bolt and a 1/2" O.D. sleeve anchol;
which are not provided. Drill the recommended size
hole %r the hardware.
[] INSTALLING THE ANTI-TIP
DEVICE (CONT.)
Wallboard
Wood screw
Back of range
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. Tile bolts must be
properly tightened as recommended tor the hardware.
E. Slide the range against the wall, and check tbr proper
installation by grasping the fi'ont edge of tile cool<top
and carehflly attempting to tilt the nmge fiwward.
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This rmlge leaves the factory set for use with natural gas.
If you want to convert to LP gas, the conversion must be
performed by a qualified LP gas installer.
The conversion instructions and I,P OlJfices can be fimnd
attached to the range next to the pressm'e regulator:
Kee I) these instructions and the orifices in case wm want
to convert back to natm'al gas.
43