Transmitter Programming - CrimeStopper Super Rage CS-2011DP Operation Instructions Manual

Dp series (data port) remote control alarm & remote engine starting system

Hide thumbs Also See for Super Rage CS-2011DP:

Table of Contents

Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or

adding remotes, ALL your system's remote codes must be learned at time of programming!! This

system allow storage of up to 4 different remote codes in memory.

1. Turn key to the ON position. (Starting the vehicle is not necessary.)

2. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.

3. Press Button #1 (Lock) of the transmitter to be learned. You should get 2 light flashes indicating the code-

learn. Now the unit is waiting for a 2

The unit will flash the lights in succession after each code learned for up to 4 codes. (2 flashes for the 2

code, 3 flashes for the 3

mode, otherwise turn key OFF and close the hood.

OFF

IMESTOPPER

TRANSMITTER PROGRAMMING

code, so repeat this step as needed with up to 3 additional remotes.

code etc.) If all 4 codes are learned, the unit will automatically exit code learning

IGN

PRESS 4X's

START

FLASH 2, 3, or 4 X's

OFF

WAIT FOR

4 FLASHES

IGN

Table of Contents