Yamaha DX9 Operating Manual page 21

е |f an ERROR message is displayed during LOAD
or VERIFY
If this happens the tape will stop. Rewind the cassette
tape to the beginning of the voice group, adjust the
level (volume) on your tape recorder, and repeat the
LOAD operation.
Simply increasing or decreasing the output level of
vour cassette recorder should correct the error, but it
may take a few tries to find the appropriate level.
If this does not correct the problem, the cause may
be one of the following:
VERIFY ERROR
1) The voices were not properly saved to excessive
speed fluctuation in your cassette recorder.
2) Improper record level (this applies to recorders
that have a record level control).
LOAD ERROR
1) Excessive speed fluctuation in your cassette re-
согдег.
2) Erroneous data recorded on data tape.
2) LOADing а single voice.
This function loads any single voice from within a voice
group, and operates basically in the same way as for
loading a voice group. Instead of pressing the [LOAD]
key, press the[LOAD SINGLE]key.
(1) Make sure the cassette recorder is properly con-
nected and set the tape to the beginning of the voice
group that contains the desired voice.
(2) Press the key and then the
key and the display will read "from TAPE to BUF
single? (1-20)", The ОХО is asking you for the number
of the desired voice.
(3) Press the preset key corresponding to the number
of the desired voice and the display will respond with
the chosen voice number and "ready? ".
zinale 18 reada?
voice number
(4) Press the[YES]key and the tape will begin playback.
The pilot tone will be heard.
(5) Set the cassette recorder volume control so that the
pilot tone is at a comfortable listening level.
(6) The display counts down the voices in the group,
and the DX9 PLAY mode is engaged when the desired
voice has been loaded. The voice number display shows
"0". The loaded voice must then be stored in any preset
number according to the STORE instructions on page 17.
€ Let's keep a record of this voice for future reference.
At the end of this manual you will find a voice data list.
Use this list to record the values of every parameter
used. Make copies of this list and use them to record the
parameters of any new voices you create yourself. This
will be useful to restore voices that have been erased,
and wil! serve as an excellent guide for creating new
voices.
<20>