Table of Contents
Advertisement
Simcenter Qsources Low Frequency Monopole Source 2v9C.docx
Operating Essentials Q-MED
Simcenter Qsources Low Frequency Monopole Source
Handle with care
Read manual
Avoid hot/cold
environments
Avoid contact with
any fluids
* In case of deviating measurement conditions, please reach out to your local Siemens contact for more information.
Store products in original flight case when not used.
·
Never leave products unattended while in operation.
·
Do not apply an excitation signal to the sensor output connection.
·
Do not operate when safety LEDs are lighting up.
·
Source should not be in safety mode for more than 30s.
·
Sensor cables must not lay alongside cables carrying power or large
·
switching currents.
Never use without electronic protection device.
·
Strong magnets inside. Never place product near (metal) debris or dust.
·
Do not apply tension to signal cables/connectors.
·
Do not move test body when product is installed.
·
Never use workshop tools to remove product.
·
Never open the housing.
·
Avoid ground loops.
·
No single sine signals.
No impulsive signals
e.g. square waves.
No signals below 10Hz.
Operate source max 5min
continuously.
16
Advertisement
Table of Contents
