Panasonic Palmcorder PalmSight PV-L750 Operating Instructions Manual page 31

Playing Back Recordings
WRI Ser, Petra ees
_TV:Playback'or. Viewing':
Connect Camcorder to a TV to view
playback or recordings in progress.
TV with AUDIO/VIDEO IN Jacks.
To Audio In ¥ J
Audio/Video
Cable
(Supplied)
wy
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
RF Adaptor
VHF Antenna
300 ohm-75 ohm
transformer
or F Connector
TV/VCR
Selector
VHF Connecting
Cable
To VHF Antenna
Terminal
Sp TORS, CAS RSET ORR RP eT ES He
UHF Antenna
SEA ASME OE Te Bar a a MR) tod Re
Before you begin...
¢ Connect Camcorder to power source.
* Make ali TV-Camcorder connections.
1 Set POWER to:
VCR — view playback.
CAMERA - view picture as it is
recorded.
2 Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
3 Begin playback or recording.
lf TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional, page 76). Tune TV to CH 3
or 4 to match RF Adaptor CH 3/4
Selector. Set Adaptor's TV/VCR
Selector to VCR for playback.
To watch TV only,
a Set Camcorder POWER to OFF.
b Set RF Adaptor TV/VCR Selector to TV.
c Turn TV ON and select channel.
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
31