Panasonic Palmcorder PalmSight PV-L750 Operating Instructions Manual page 12

Charge Battery Pack fully before use.
———
=
1
BATTERY j
PACK
c_
SS
1 Plug in AC Adaptor.
POWER Lamp lights.
2 Insert Battery.
@ Align right side of Battery with line
on AC Adaptor.
@ Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
Lamp 1
3 Remove Battery
Slide Battery out and off.
Note: * Battery life gradually decreases after
REFRESH feature as explained on page 13. time becomes very short, even after a
sufficient charge, discard Battery properly
{page 13).
eUsingithelBattery;Pack?
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
1 Attach Battery
@ Align Battery with top of mounting
surface.
SER © Press and snap into place.
PACK 2
Remove Battery
While sliding BATTERY RELEASE,
remove Battery. :
12 For assistance, call 1-800-211-PANA(7262)