Additional Information; Changing The Digital Security Code; Installing The Beltclip; Headset Installation - Uniden EXI976C User Manual

• To protect you against
misbilled calls which
might result from your
phone being activated
by other equipment,
the cordless phone
provides AutoSecure TM
(which electronically
locks your phone when
the handset is in the
base) and Random
Code TM digital security
(which automatically
selects one of over
262,000 digital
security codes for the
handset and base).
• If the handset battery
pack is completely
discharged or the
battery pack is
removed, the digital
security code will be
lost. If this happens, a
new security code is
set automatically the
next time the battery
pack is charged.
[ 38 ] A D D I T I O N A L I N F O R M A T I O N

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. The first time you charge
your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the base unit. Press and hold the find hs key on the
base.
2) While holding the find hs key, place the handset in the base unit, and leave the
handset on the base for more than 3 seconds. A new random security code is set.

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.

Headset Installation

Your phone may be used with an optional headset, the Uniden HS910.
To use this feature, insert the headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department or
visiting the web site. See QUICK REFERENCE GUIDE on page 3.)
www.uniden.com