Table of Contents
Advertisement
Orbi Pro WiFi 6 AX5400 Router Model SXR50 and Orbi Pro WiFi 6 AX5400 Satellite Model SXS50
The user name is admin. The password is the one that you set the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup > LAN 1.
The LAN Setup page displays.
5. In the IP Address field, type the IP address.
The default IP address is 192.168.1.1.
6. In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identifies which addresses are local to a specific
device and which must be reached through a gateway or router.
The default IP subnet mask is 255.255.255.0.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information
with other routers.
a. Select a setting from the RIP Direction menu:
• Both: The router broadcasts its routing table periodically and incorporates
information that it receives.
• Out Only: The router broadcasts its routing table periodically.
• In Only: The router incorporates the RIP information that it receives.
b. Select a setting from the RIP Version menu:
• Disabled: This is the default setting.
• RIP-1: This format is universally supported. It is adequate for most networks,
unless you are using an unusual network setup.
• RIP-2: This format carries more information. Both RIP-2B and RIP-2M send
the routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M
uses multicasting.
8. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address of the router, you are disconnected when this
change takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router.
Manage the LANs
110
User Manual
Advertisement
Table of Contents
