Emptying The Dirty Water Tank - Bissell PROHEAT 2X REVOLUTION PET Manual

Cleaning with Hose and Tools (continued)
Stain Trapper Tool
1. Point tool about 2 cm above 2. To empty tool tank, rotate
spot or stain and press trigger. clockwise. Pour dirty liquid
Suction stain by placing tool into sink or toilet and rinse.
on surface and slowly moving Allow time to air dry.
backwards.
2-in-1 Upholstery Tool
Dry
Suction
Channel
Switch between dry Dry Cleaning
and wet settings.
Vacuum up debris from
Turn machine ON.
carpet or upholstery.
Emptying the Dirt Bin
1.
Twist dirt bin to open. Empty debris into a garbage bin.
2. Rinse dirt bin. Let dry completely before reinstalling.
8 global.BISSELL.com
3. Reattach tank by lining up
grooves and twisting into place.
Wet
Suction
Channel
Wet Cleaning
1. Hold down trigger to activate spray.
2. Release trigger and suction up the stain.

Emptying the Dirty Water Tank

For more helpful tips, check out global.BISSELL.com.
1. Press tank handle 2. Empty tank. Quick empty: Pull rubber tab and tilt to
and tilt tank toward pour. When closing, ensure tab is sealed tight.
you. Grab handle Final clean and rinse: Unscrew ring at bottom of tank.
and tank with both Remove and rinse float stack. Reinstall float stack by
hands and pull up aligning arrows and lock into place. Twist and lock ring to
and away to remove. keep water from leaking.
Note: It is common to refill the clean water tank and empty the dirty water tank multiple times
throughout your cleaning process. Room size and the speed at which you clean are both factors that
affect how often the tank may need to be refilled and/or emptied.
After-Cleaning Care
Rinsing the Machine
1. Rinse out the clean water tank to remove formula. Fill tank with warm tap water. Twist cap back
on tightly.
2. Turn machine ON and press trigger for 15 seconds while making back and forth passes on a section
of carpet. Release the trigger and extract the water. See above to clean the dirty water tank.
Cleaning the Brush & Nozzle
1. Press two release buttons 2. Rinse the nozzle. Use the
and lift up to remove cover. clean out tool to unclog debris.
Use the comb to brush out
debris from the brush rolls.
Important:
The float stack
prevents your
dirty tank from
overflowing.
3. Clean red
filter below
tank by
wiping off any
remaining dirt
or debris.
3. Reinstall cover by pushing
down until both sides click.
global.BISSELL.com 9