Table of Contents
Advertisement
English
► Position the control handle (8) on the handle‐
bar (3) so that the hole of the control handle
aligns with the hole of the handlebar and the
trigger faces toward the gear housing.
► Fit the nut (7).
► Insert the screw (6) and tighten it securely.
It is not necessary to remove the bike handle
again.
8.2
Mounting and Removing the
Deflector
8.2.1
Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
1
2
The line limiting blade (1) has already been
installed in the guard (2) and must not be
removed.
► Push the deflector (2) into the guides on the
gear housing up to the limit stop.
► Insert the screw (3) and tighten it securely.
8.2.2
Removing the Deflector
► Switch off the brushcutter and remove the bat‐
tery.
2
► Unscrew the screw (2).
► Pull off the deflector (1).
8.3
Mounting and Removing the
Mowing Head
8.3.1
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
12
2
3
4
1
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
8.3.2
Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove the stop pin.
8.4
Removing and Installing Metal
Cutting Attachment
8.4.1
Mounting the Metal Cutting Attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
8 Assembling the Trimmer
1
2
3
4
4
0458-028-0101-A
1
Advertisement
Table of Contents
