Cloning The Scanner - Uniden SC230 Owner's Manual

SC230 Paper OM.fm Page 43 Wednesday, October 6, 2004 10:51 AM

Cloning the Scanner

To clone (copy) data from one SC230 scanner to another
SC230 scanner, you must first connect the scanners to
each other using the included connection cables and a
DB9 null modem adapter and DB9 gender changer
(neither included), available at most computer stores.
Then you must set one scanner as the master (source)
and the other as the slave (destination).
Note: You can also copy data to your SC230 scanner
using a radio transmitter and a personal computer.
Plug the smaller end of each of the included connection
cables into Remote on the right side of each scanner.
Then connect the other end of the cables together using
the null modem connector and gender changer.
Then set up both scanners.
Xfer Information
Menu
E
WIRED Clone
• Master This will be the master (source) scanner.
• Slave This will be the slave (destination) scanner.
(Master scanner) E
(Slave scanner) E
When you are ready to clone the scanner, press Scan on
the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on both
scanners. If the transfer did not work, Error appears on
the master scanner.
E
Clone Master Press SCAN Key
Clone Slave Press SCAN Key
Other Settings
43