Kenwood TH-75A Instruction Manual page 4

3. BATTERY PACK
This battery pack has not been charged at the factory in
order to provide you with the greatest number of charge/dis-
charge cycles. You must charge the battery before use. The
battery pack will require several charge/discharge cycles be-
fore you can expect to see the maximum operating period
between charges. If the battery will be stored for greater
than 2 months it should be recharged before use.
3-2. RECHARGING Msxe"
1. Slide the adapter onto the
NiCd battery pack.
2. Plug the supplied charger
into an AC outlet.
3. Do not allow the battery to
charge for greater than 15
hours.
The useful life and battery
performance will be
reduced if you exceed the
recommended charge
period.
NOTE:
Recharging should be per-
formed within an ambient
temperature range of between
5°C~40°C (41°F ~
104°F).
Recharging the battery out-
side of this range may not al-
low the battery to reach full
charge.
to AC outlet
Install 6 x R6 (AA) manganese
or alkaline batteries in the bat- Press down on the hook in the
tery holder.
Pay close atten-
'Middle of the battery case top
* ty to open.
tion the battery polarities
marked in the holder. We Hook
recommend the use of high |
performance manganese bat-
teries for the greatest operat-
ing time.
NOTE: ——________
Do not install NiCd batteries
and attempt to charge them
with the supplied charger.
There is no battery protection
circuit in the battery holder.
Align the grooves in the bat- Release button
tery pack with the transceiver >
and slide the pack to the right
until it locks in place.
To remove the battery pack
push up on the release button
and slide the pack to the left.