Kenwood TH-75A Instruction Manual page 19

1. In the Memory channel
mode or CALL channel | |- nanan 7
mode press the ENT key. | |Y4u.uuu 5 (45207
The display will indicate (UE APO
the ENTER mode frequen-
cy status, 2
2. Within 10 seconds of
pressing the ENT key, ro-
tate the tuning control to | | 4- 7.7 ~~ 45.888
=u
the desired frequency. The \ eaten]
Memory Channel or CALL
Channel indicator will turn
OFF to signal the data has
been successfully trans- | |_ oH
VFO. nan
fered Seen wo.guU 45.008
SAVE APO
NOTE:
1. If you do not need to change the frequency after shift-
ing the Memory contents to the VFO simply press the
ENT key twice.
2. If an Odd Split Memory channel is selected, only the
receive data will be copied.
4-5. SCAN
4-5-1. SCAN OPTIONS
The following scan options are available:
Band scan
Scan proceeds over the entire main band. This func-
tion operates in the VFO mode only.
Programable Band scan
The scan range in this mode is specified in main band
memory channel 8 and 9. This function operates in
the VFO mode only.
Memory Channel Scan
Scan proceeds thru those main band memory chan-
nels that have data stored and have not been locked
out.
This function operates in the Memory Channel mode
only.
Double Memory Scan
Scan proceeds thru all sub memory channels that have
data stored and have not been locked out simultane-
ously with main memory channels. This function oper-
ates in the both Memory Channel modes only.
Scan will not function when the Tone Alert System is active.
4-5-2. HOLD/RESUME PROGRAMMING
Two type of scan hold/resume have been provided in this
transceiver.
Time Operate scan (TO)
You may prefer that the radio stops on a busy chan-
nel and remains there approximately 5 seconds, and
then continues to scan even if the signal is still
present.
19