Kenwood TH-75A Instruction Manual page 25

SINGLE BAND OPERATION
To activate the keypad:
1. Press and hold the PTT switch.
1. Press the F key. The F in- 2. Press the keys just lik dial y o u r
Ear vail ight Cc) i ee eys just like you would dial your telephone
2. Press the 3/CTCSS key wi- cTcss
thin 10 seconds of press- 'olumn
ing the F key. The CTCSS 1209 1336 1477 1633
indicator will light. ' Row
3. To turn off the CTCSS
yuf 09
679 1 2
3 VIA
function, press the F key iB
and then the 3/CTCSS key 7 pre 6 MIB
again. 852 ve 8 9 ENT/C
4-6-4. AUTOPATCH (U.S.A. version only) = ta o us SEANID
Some repeaters offer a service known as autopatch. This
feature allows you to dial a telephone number from your NOTE:
transceiver and carry out a telephone conversation, much
like a car telephone, or cellular telephone. This function re-
quires the use of a DTMF (Dual Tone Multi Frequency) pad.
In addition to the normal 12 keys that are found on your
telephone the transceiver also provides 4 additional keys,
A, B, C, and D. These keys are used for control purpose on
some repeater systems. You should check with the control
operator of the repeater to see if they offer autopatch serv-
ices. A chart is provided that lists the various tones frequen-
cies that are generated by the keypad.
Some repeaters will require the use of a special key se-
quence to activate the Autopatch function. You should
check with your control operator for this sequence.
25