Connecting The Optional Utc (Universal Transparency Cover) Cable; Connecting The Power Adapter - UMAX Technologies Astra MX3 Owner's Manual

Note: SCSI ID numbers 0 and 7 are used by the computer and by the hard
drive. SCSI ID numbers 8 and 9 are settings for factory-use only and could
cause damage to the scanner if used as a SCSI address for a peripheral.
Connecting the optional UTC (Universal Transparency
Cover) Cable
Note: The Universal Transparency Cover is available as an optional
accessory. With the UTC, you'll be able to scan slides and other transmissive
media.
1. Locate the UTC cable connected to the back end of the UTC cover.
Optional
Universal
Transparency
Cover
UTC Connector
2. Plug the UTC cable connector into the round three-pin DIN connector on
the scanner's back panel.

Connecting the Power Adapter

1. Plug the scanner's power adapter into an electrical outlet.
2. Insert the other end of this cable into the power adapter receptacle on the
rear panel of the scanner. The power indicator on the front panel of the
scanner should now be illuminated.
3. Turn your computer on.
14
UTC Cable