Quick Start Guide; Connecting The Scsi Cable - UMAX Technologies PowerLook 3000 Operation Manual

Quick Start Guide

This section serves as a quick reference to the connection and installation procedures
for the PowerLook 3000 scanner.
1. Unpacking your Scanner
Unpack your scanner. Make sure that all the scanner system hardware, software,
cabling and documentation items indicated on the packing list are present.
2. Connecting the Interface Card (for PC users only)
a) Turn off your computer and remove the computer's housing cover.
b) Locate an available 16-bit slot.
c) Insert the SCSI card by pressing it gently but firmly into the slot. Make sure it is
firmly seated in the slot.
d) Replace the computer's housing cover.
Note: If you already have a SCSI card installed on your computer:
When installing the software, you will be asked to choose TYPICAL or
CUSTOM installation. Choose CUSTOM and select "Adaptec or other ASPI
Compatible Interface Card" when installing the scanner driver. Otherwise, the
scanner will not work properly.

3. Connecting the SCSI Cable

Connect the SCSI cable to the SCSI interface card and the other end of the SCSI
cable to the scanner.
If your scanner is not chained to other SCSI devices or at the end of the SCSI chain,
please connect the terminator to the remaining SCSI port of your scanner.
iv