Table of Contents
Advertisement
Chapter 2
Installing the Subscriber Station
10. Tighten the screws connecting the arm bracket to the subscriber station and mounting bracket. Make sure the
screws are torqued to 24 N·m (17.7 ft. lb.).
Section 2.6.2
Mounting the Subscriber Station to a Pole
The subscriber station can be attached to any pipe or pole with a diameter of 44.5 to 254 mm (1.75 to 10 in).
To mount the subscriber station to a pole, do the following:
1.
Attach the subscriber station to the mounting bracket.
Figure 5: Mounting the Subscriber Station to a Large Pole
1. Subscriber Station 2. Pole 3. Clamping Bracket 4. Mounting Bracket 5. M8-25 Hex Screw 6. M8 Spring Washer 7. M8 Flat
Washer 8. M8 Nut 9. M8-70 Hex Screw
12
4
3
5
6
1 7
1
8
6
7
7
Mounting the Subscriber Station to a Pole
RUGGEDCOM WIN5158
Installation Guide
2
3
6
9
Advertisement
Table of Contents
