Electrolux EWED65HSS Installation Instructions Manual page 7

7
Installation Requirements
Exhaust system requirements, continued
+ Compression or crimping of the exhaust system
M WARNING Will cause an Increase In vent restriction.
EXPLOSION HAZARD
+ The exhaust system should be Inspected and
Do not Install the dryer where gasoline or other
Tlammables are kept or stored. Ir the dryer Is
Installed In a garage, It must be a minimum of 18
Inches (45.7 cm) above the floor. Fallur to do so
can result In death, explosion, Tire or bums.
1. Connect an inclined or digital manometer
cleaned a minimum of every 18 months with
normal usage. The more the dryer Is used,
tha more often you should check the exhaust
system and vent haod Tor proper operation.
Exhaust direction
between the dryer and the point the exhaust
connects to the dryer.
2. Betthe dryer timer and temperature to alr Tutt
(cool down) and start the dryer.
Directional exhausting can be accomplished by
Installing a quick-turn 90 dryer vent albow directty
to exhaust outlet of dryer. Dryer vent eibcws are
avallable through your lacal parts distributor or
3. Read the measurement an the manometer.
4. The system back pressure MUST NOT be
higher than 1.0 Inch of water column. Ifthe
system back pressure Is lass than 1.0 Inch of
water column, the system Is acceptable. If the
manometer reading Is higher than 1.0 Inch of
water column, the system Is too restrictive and
tna Installation Is unacceptable.
Although vertical orlentation of the exhaust system
Б acceptable, certain extenuating circumstances
could affect the performance of the dryer:
* Only the ngid metal duct work should be used.
* Venting vertically through a roof may expose
tna exhaust system to down drafts causing an
Increase In vent restriction.
* Running the exhaust system through an
uninsulated area may cause condensation and
faster accumulation of Int.
1. Installation MUST conform to current
Manufactured Home Construction & Safety
Standard, Title 24 CFA, Part 32-80 (formerly tha
Federal Standard Tor Mobile Home Construction
and Safety, Tite 24, HUD Part 280) or Standard
GABN/ACSA P240 MH.
2. Dryer MUST be exhausted outside (outdoors, not
beneath the тобе home) using metal ducting
that will not support combustion. Metal ducting
must be 4 Inches (10.16 cm) їп diameter with no
obstructions. Rigid metal duct Is prefered.
3. IT dryer I5 exhausted through the Toor and
area beneath the mablle home Is enclosed,
hardware store.
Bee also CLEARANCE REQUIREMENTS on the
next page.
= NOTE
Use of 90° quick-turn elbow required to meet
minimum installation depth.
Manufactured or mobile home installation
4.
8.
8.
the exhaust system MUST terminate outside
the enclosure with the termination securely
fastened ta the тоба home structura.
Refer to previous sections In this guide Tor other
Important exhaust venting system requirements.
When Installing a gas dryer Into а mobile home,
a provision must be made for outside make up
alr. This provision Is to be not less than twice
tha area of the dryer exhaust outlet.
Installer MUST anchor this (1) dryer or (2) dryer
Mounted on pedestal to the floor with approved
Mablle Home Installation Kit - P/N 137067200.