Electrolux EWED65HSS Installation Instructions Manual page 19

Reversing Door 19
Preparing to reverse door swing
1 Be sure you have adequate swing area before reversing door.
2 'You Will need a screw driver with a #2 square bit.
3 Protect nat work surface, such as top of dryer or floor near dryer,
with a sort cloth or towel.
Fallure to disconnect power sources before servicing
could result In personal Injury or even death.
Removing door and hardware
A Removing Trim Ring B) Removing Door from Front Panel
1 Open door to 90 degree angle. 1 Reopen door to 80 degres angle.
2 Remove and save trim plug and long, 2 Remove 2 short, course-thread, panhead
coursae-thread, panhead screw. Screws.
з While supporting door with the other папа,
remove 3 short, fné-thread, countersunk
Screws.
3 Class door
4 Rotate door tim approximately 4" counter-
Clockwise and pull ing away fram door.
4 Genty place door Tace down on flat, covered
work surface.