Electrolux EWED65HSS Installation Instructions Manual page 16

16
Installation Instructions
Water connection, con't (Steam Model only)
1. m your Installation has mom tor the COLD
water supply to accept the "Y" connector
directly, thread the "Y" connector to tha GOLD
water supply and snug It by hand; then tighten
It another 2/3 turn with pliers.
= NOTE
туси were able to Install tna "Y" connector directty
tothe COLD water supply, please skip to step В.
2. ff there Is not room to Install the "Y" connector
directly, thread the short extension hose on to
the COLD water supply and snug It by папа;
then tighten It another 2/3 tum with pliers.
3. Thread the "Y" connector to the short
extension hose and snug It by hand; then
tighten It another 2/3 tum with pliers.
4. Connect the COLD Inlet nose Tor tha washer
to tna "Y" connector and snug It by папа; then
tighten It another 2/3 tum with pliers.
5. Connect the straight end of the long hose from
the kitto the other outlet on the у" connector
and snug її by hand. Connect the hoses 90°
coupling to the brass water Inlet on the back
of the dryer and snug It by папа. Tighten each
connection of the dryer Inlst hase another 2/3
tum with piers.
6. Tum onthe water and check Tor leaks at all
connections.
DIRECT CONNECTION
„= OR WITH EXTEN SOM
WATER INLET ON DAYER