Table of Contents
Advertisement
Installing the audio board
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the audio board and provides a visual representation of the installation procedure.
Steps
1. Connect the audio board to the system-board assembly.
2. Align the screw holes on the audio board with the screw holes on the system-board assembly.
3. Replace the two screws (M2x3) that secure the audio board to the system-board assembly.
4. Turn the system-board assembly over.
Next steps
1. Follow the procedure from step 5 to step 25 in
2. Install the
rear I/O
cover.
3. Install the
top
heat-sink.
4. Install the
small
fan.
5. Install the
wireless
card.
6. Install the
M.2 2230 solid-state drive
7. Install the
M.2 2280 solid-state drive
8. Install the
memory
module.
9. Install the
base
cover.
10. Follow the procedure in
Installing the system
in slot three and four, if applicable.
or
M.2 2230 solid-state drive
After working inside your
board.
in slot one and two, whichever is applicable.
computer.
95
Advertisement
Table of Contents
