Table of Contents
Advertisement
Figure 16
2. Locate the compression fitting and ferrule packed with
the unit. Slide the compression fitting and ferrule over
the 1/4-inch OD water supply line. Do not use thread
sealing compound or tape. Using two wrenches,
tighten the compression fitting on the supply line (see
Figure 16).
3. Carefully bend the water supply line into position and
connect the line to the solenoid valve (see Figure 17).
Avoid kinking the water supply line.
Figure 18
IMPORTANT
Normal operation creates some vibration. A water supply
line contacting cabinet wall may cause excessive noise
during operation or damage to the line.
4. For recessed installations, allow extra water supply line
length to provide slack for easy removal from the
recessed area (see Figure 18). This will also safeguard
against kinking the line.
5. Go on to 7 Prepare Power Supply.
www.U-LineService.com
CO1175 — Ice Maker/Refrigerator
Water
Connection
Figure 17
7 Prepare Power Supply
Electrical Specifications
Electrical installation must observe all state and local
codes. This unit requires connection to a grounded (three-
prong), polarized receptacle that has been placed by a
qualified electrician.
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A power supply (normal household current).
An individual, properly grounded branch circuit or circuit
breaker is recommended. GFCI (ground fault circuit
interrupter) is usually not required for fixed location
appliances and is not recommended for your unit because
a GFCI could be prone to nuisance tripping. However, be
sure to consult your local codes.
See Figure 19 for recommended receptacle location.
Figure 19
SHOCK HAZARD — Electrical Grounding Required.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
Go on to 8 Level the Unit.
10
CAUTION
7"
4"
WARNING
24"
11/2006
Advertisement
Table of Contents
