Service Information ......13 www.U-LineService.com CO1175 — Ice Maker/Refrigerator 1 Follow Safety Precautions PLEASE READ all instructions completely before attempting to install or operate the unit.
CO1175 — Ice Maker/Refrigerator 2 Inspect and Plan You have received a carton containing your CO1175 Ice Maker/Refrigerator with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
CO1175 — Ice Maker/Refrigerator 3 Prepare Site Your U-Line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for water and electrical connections in the rear.
Door Swing/Clearances Information Black units have a zero clearance for the door to open 90° (see Figure 3). U-Line recommends a minimum door clearance of 1/4" for black units. Stainless Steel units require a minimum of 2” door clearance to accommodate the handle if the unit is installed next to a wall or similar type of structure.
5. Remove bottom hinge from cabinet (four screws) and screws on opposite side of cabinet. See Figure 7. www.U-LineService.com CO1175 — Ice Maker/Refrigerator 6. Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge. See Figure 6.
Instructions For a complete refreshment center, install two of the following 1175 series units side by side: CO1175, 1175R Refrigerator or 1175WC Wine Captain Side-By-Side Installation will be different. • Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide.
1. Remove top hinge screw pin with a Phillips head screwdriver. Remove door by tilting forward and lifting off bottom hinge pin. www.U-LineService.com CO1175 — Ice Maker/Refrigerator Figure 12 2. Pull door gasket out of groove (top edge of door only).
(see Figure 18). However, make certain that the tubing is not pinched or damaged during installation. • U-Line recommends the use of copper tubing for installation. To connect to water supply: 1. Install the 1/4 inch OD copper water line from the main water source.
(see Figure 18). This will also safeguard against kinking the line. 5. Go on to 7 Prepare Power Supply. www.U-LineService.com CO1175 — Ice Maker/Refrigerator 7 Prepare Power Supply Electrical Specifications Electrical installation must observe all state and local codes.
Readjust the front feet to level the unit after it is correctly positioned in the opening. 11/2006 CO1175 — Ice Maker/Refrigerator 9 Install the Unit Installation of the CO75A 1. Open the water supply valve in the main water source.
Always throw away all ice cubes made during the first twenty-four (24) hours of operation. The ice bucket MUST be fully inserted to avoid freezing products in the refrigerator section. The ice bin door must be fully closed. Figure 25...
This is normal and is caused by air being trapped in the cube during fast freezing. For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter icemakers, Combo refrigerators, refrigerated drawers and refrigerator/freezers.