U-Line Echelon 2075DWRRSS Supplementary Manual page 3

Remove existing drawer front from
cabinet:
1. Open drawer. Pull door gasket
(Figure 2) out of the groove
(top edge of door only). Start in
the middle and pull outward,
moving toward the edge. This
may take some force.
2. Remove the two screws locat-
ed on both sides of the lower
handle. Remove the handle
(Figure 3).
3. Slide the existing drawer panel
and cardboard spacer out of
the drawer frame. Discard the
spacer.
Attaching the full overlay panel:
4. If required, attach optional
cabinet handle hardware to
the overlay panel at this time.
If an optional cabinet handle is
installed,
mounting screw heads are
countersunk.
NOTE:
For 1/2" gap between
top and bottom panels,
this dimension must be
11/32".
make sure
SIDE OF
BACK OF WOOD PANEL
WOOD PANEL
HANDLE
SCREW
the
TAPE
11/32"
BOTTOM
3/8" BOTH SIDES
Figure 4
Figure 2
Figure 3
DOOR PANEL
BOTTOM OF
WOOD PANEL
DWR_OL_003a
GASKET
DWR_OL_001
DWR_OL_002