Canon Super G3 FAX Board-AS Service Manual page 61

NOTE:
This step is only for Europe.
Do not connect the Telephone Cord (2 contact type)
with the PTT Plug.
9. Connect the PTT Plug matched the field or area to
the PTT Cable (6 contact type).
1x
10. Connect the end of the PTT Cable or Telephone Cord
to the modular jack on the Host machine, and
connect the other end to the modular jack on the
wall.
1x
11. Install the Rear Cover 2.
• 2 Protrusions
• 3 Screws
3x
12. Install the Left Rear Cover.
• 1 Hook
• 1 Claw
Claw
Hook
13. Connect the Power Plug to the outlet.
14. Turn ON the main power switch.
CAUTION:
If the machine does not recognize this equipment,
unplug and then plug the power plug after turning OFF
the main power switch, or turn OFF the main power
switch and then turn it ON within 20 seconds.
To avoid this symptom, unplug the power plug or turn
the breaker OFF when installing.
NOTE:
After completion of this procedure, proceed to
the Operation" on page
56
6. Installation
Protrusion
"Checking
68.