Canon Super G3 FAX Board-AS Service Manual page 39

NOTE:
Error codes caused by line status at the time of transmission
##100, ##101, ##102, ##104, ##201, ##280, ##281, ##282, ##283, ##284, ##750, ##752, ##754, ##755, ##757, ##759, ##760,
##762, ##764, ##765, ##767, ##769, ##770, ##772, ##774, ##775, ##777, ##779, ##780, ##782, ##784, ##785, ##787, ##789
Error codes caused by line status at the time of reception
##103, ##106, ##107, ##201, ##793
008: Upper limit for V.34 modulation speed
Select the upper limit of the modulation speed (baud rate) in the V.34 primary channel.
When 4 (2743 baud) is selected, the communication is actually performed at 2400 baud.
009: Upper limit of V.34 data speed
Select an upper limit of data transmission speed in the V.34 primary channel in the range between 2.4k and 33.6kbps at 2400bps
intervals (0: 2.4 kbps to 13: 33.6 kbps).
010: Pseudo CI signal frequency
Set pseudo CI signal frequency.
Depending on the type of external phones, there is no ring tone when the FAX/TEL switching function is working. Change the
pseudo CI signal frequency when there is no ring tone.
34
5. Service Mode