Control Operation; Power Button; Volume (Vol) Buttons; Mute Button - Panasonic CT-32G11 Operating Instructions Manual

Hide thumbs Also See for CT-32G11:
Table of Contents

Advertisement

Control Operation
Power Button-
Press the POWER button to turn
ON. Press again to turn OFF.
Volume
Button
-
Press the VOLUME (VOL)
LEFT/RIGHT
button for desired listening level (when
On-Screen menus are not displayed).
Located On Remote Control
Increases
Decreases
Volume Level
Channel Change
(UP/DOWN)
Press the CHANNEL (CH) UP/DOWN button to sequen-
tially scan through programmed
channels (when On-
Screen menus are not displayed).
NOTE: TV/CABLE switch (located on Remote) must be
set in TV position.
TV/CABLE
l--q
Located on Remote Control
Selects Next
herChannel
Selects Next
Lower Channel
Mute Button
- Press the MUTE button to quickly
reduce sound level (Mute will appear on screen). Press
again to restore sound.
MUTE
R-Tune Button
- Pressing the R-TUNE (RAPID
TUNE) button will switch between the last two channels
selected on the numeric keypad.
NOTE: When
rapidly scanning channels with the
CHANNEL
UP/DOWN
button,
pressing the
R-TUNE button will switch between the last
channel scanned, and initial channel atthe start
o1scanning.
R-TUNE
CHANNEL NOW
BEING VIEWED
Press Button
Press Bu_on Again
!
CHANNELTUNED
IMMEDIATELY
BEFORE
Helpful Hints:
• Helpfulinformationwll displayOn Screen momentarily
when Receiver is first turned on and when the
channel is changed,
• When using keyboard entry for channels 10,11, and
12 in the CABLE mode, there is a slightdelay before
channel change because of the capability of tuning
cable channels 100 to 125,
Numeric Keypad (0
througl_
9 Buttons)
Press two digits on the numeric keypad 0 through 9
buttons (Example press 0, then 5 for channel 05). For
channels over 99, press three digits on keyboard.
®'
®J
VCR
Function
Buttons-
The VCR
FUNCTION
buttons have been designed
to operate
numerous brands of VCRs. The infrared code must be
obtained prior to use. (Please refer to Programming the
Universal Remote for programming instructions.)
NOTE: The TV/CABLE
switch (located on Remote)
must be in the TV position.
IvcR Po_;
LO @I
REW
STOP
PLAY
FF
I
TV/VCR
VCR CHA_L
PAUSEI
I
O<ZZ)(D
C) l
l
-10-

Advertisement

Table of Contents
loading

Table of Contents