Table of Contents
Advertisement
Set-Up Features (cont.)
Mode (TV or Cable)
NOTE: The proper input mode must be selected for
the type of signal at the antenna input.
• TV is used when the TV is not connected to a Cable TV
System, for example, when using a VHF/UHF antenna
(Channels 02-69)
• CABLE is used when the TV is connected to a Cable TV
System and when not using a cable box (Channels
01-125)
Note:
Some Cable TV Systems encode (scramble)
program material on specific channels. A cable
company supplied decoder is required to produce
an acceptable picture. Certain Cable TV Systems
offset some channels to reduce interference. It is
necessary to use the cable company supplied
cable box to receive these specific channels.
1.
Press
2.
Press ^ or^ and ^ or ^ to highlight the Set Up
Icon.
3.
Press ^3) to display the Set Up Menu.
4.
Press ^ or^ to highlight MODE.
5.
Press ^ or ^ to select TV or CABLE.
6.
Press (^3 twice to exit menus.
Auto Program
Used to Place all channels carrying a video signal into
Channel Scan Memory. When ^ or^ is pressed, only
channels with a video signal will be accessed.
Note: TV or Cable Tuning mode must be set properly.
1.
Press
2.
3.
Press ^ or^^ and ^ or ^ to highlight the Set Up
Icon.
Press
to display the Set Up Menu.
4.
Press A or^ to highlight AUTO PROGRAM.
5.
Press ^ or ^ to start Auto Programming Scan.
Channels will automatically advance until all channels
have been scanned.
Note: Channel numbers with video signal present will
turn blue. This indicates that channel is included in
the Channel Scan Memory.
6.
Press (^3 twice to exit menus.
Helpful Hints:_
After Auto Programming:
All channels are available by direct access using the
numeric keypad (0 through 9 buttons).
Up to 15 channels will be programmed into the FAVORITE
Channel Scan after Auto Programming Scan has been
completed. Any original channels that were programmed
Into FAV CHANNEL will remain. (Refer to Favorite
Channel Scan for deleting unwanted channels.)
-
26
-
Advertisement
Table of Contents
