Testing The Setttings In The Clone Box; Testing The Clone Box Battery; Resetting The Tv To Normal Mode; Switching To Comercial - Panasonic CT-2511HDB Service Manual

Testing the Settings in the Clone
Box
This test compares the clone box settings with
the television settings. The television must be
in Commercial (Hotel) mode.
1. Press the POWER ON button on the
clone box.
• The LEDs will flash red and green to
confirm power is ON.
2. Connect the clone box to the Digital
Interface port on the back of the
television.
• The television must be plugged into an
AC outlet but can be either OFF or ON.
3. Press the TEST button.
• The LEDs will flash red and green while
the data is compared. The green LED will
light for about two (2) seconds if the
settings in the box match the television.
4. Disconnect the clone box from the
television and turn it OFF.

Testing the Clone Box Battery

1. Press the POWER ON button on the
clone box.
• The LEDs will flash red and green to
confirm power is ON.
2. Hold the ALT button while pressing the
TEST button.
• The LEDs will alternately flash red and
green while the box is tested.
Note: Replace the 9 volt battery if the LEDs
do not flash red and green.
• The green LED will light for about two (2)
seconds, if battery is charged.
Note: If the green LED does not light for
about two (2) seconds at the end of
the test,
downloaded into the box.
new data must be
- 27 -
Resetting the Television to Normal
TV Mode
1. Press the POWER ON button on the
clone box.
• The LEDs will flash red and green to
confirm power is ON.
2. Connect the clone box to the Digital
Interface port on the back of the
television.
• The television must be plugged into an
AC outlet but can be either OFF or ON.
3. Press the AMS button.
Note: Insert a slender tool about 3/4 inch
(paper clip) into the opening.
• The green LED will flash while the
television is reset to Normal TV mode.
The green LED will light for about two (2)
seconds when the procedure is complete.
4. Disconnect the clone box from the
television and turn it OFF.
5. Press the ACTION+POWER buttons
on the front of the set for 5 seconds to
complete the change to normal TV
mode. The receiver momentarily shuts
off; then comeback on tuned to
channel 3 with a preset level of sound
and display the self-check screen. Any
programed channel and other user
defined settings will be lost, except
channel caption.
Switching to Commercial (Hotel)
Mode
Adjust the features listed in the Commercial
(Hotel) Mode Feature Chart before switching
modes.
1. Press the ACTION (6
VOL u (3) button simultaneously.
2. Within a second, press the ACTION (6)
button and the CH p (5) button
simultaneously.
3. ON will flash in red in the lower corner
of the screen, indicating Commercial

(Hotel) Mode.

Switching to Normal TV Mode

1. Repeat steps 1 and 2 from the
previous section.
2. OFF will flash in red in the lower corner
of the screen, indicating Normal TV
Mode.
*Refer to the illustrations of the front panel in the section
entitled Location of Controls

) button and the