Panasonic NE-7920 Service Manual page 19

MEASUREMENTS AND ADJUSTMENTS
NOTE: Please note this model has no test resistor for measuring diode or anode current. When you check the high voltage
Circuit, follow the procedure in the troubleshooting guide on page 24.
§ WARNING §
DURES BELOW.
1. Adjustment of latch switch A (primary)
(A) Mounting of the latch switch to the door hook.
Mount latch switch A to the door hook assembly by
securing the screws as shown in fig. 29 & 30.
Door hook
assembly
Fig. 29
When mounting the door hook assembly to the oven
assembly, be sure to adjust the door hook assembly
by moving in the arrow direction so that the oven
door will not have any play in it.
Check for play in the door by pulling on the door
NOTE:No specific adjustment during installation of
latch switch-A to the door hook is necessary.
Latch switch A
Fig. 30
handle without pushing the handle's latch button.
Make sure that the latch key positions correctly
during adjustment. Also make sure that the latch
key moves smoothly after adjustment is completed.
Completely tighten the screws holding the door
hook assembly to the oven assembly.
Latch switch A
Door hook assembly
Oven surface
Fig. 31