38MBRC: Service Manual
Procedure
1) Remove 2 screws to disconnect the
power supply wires.
2) Remove 3 screws to disconnect the
wires connected to the compressor.
3) Remove 3 screws to remove the
radiator.
4) Disconnect the wires between the IPM
module board and main control
board.
5) Remove the 4 screws and loosen
the 4 hooks then remove the IPM
IPM module board.
6) Remove the 1 screw and disconnect
the wires then remove the 24V board.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Illustration
Compressor
DC Fan motors
connect to main control board
48