Pioneer PD-T507 Service Manual page 3

AND GEAR II
Set the following gears to the position as shown by arrows.
Protrusion
Gear | Gear Il
Main cam
Follow gear
Follow gear
Fig. 4
@ MOUNTING OF CLAMPER ASSEMBLY
Mount the clamper assembly by aligning the protrusion portion
as shown in the figure.
Protrusion
Fig. 5
@ REMOVING THE BONNET
1. Remove six screws to the bonnet.
2. Remove the bonnet by pulling up it in the vertically
direction of arrow.
To easily remove the bonnet, pull outward on both sides of
the bonnet then pull it diagonally toward the rear of the unit.
Note: If you pull up the rear base of the bonnet to remove it as
in the conventional manner, the hooks shown in Fig. 6
may be caught and the hooks on the front panel side may
be deformed.
Nail section
Front panel A
Fig. 6
www.rtvcenter.com
repairtips, servicemanuals
forum, chassispictures. . .