Pioneer PD-T305 Operating Instructions Manual

TWIN-TRAY COMPACT DISC
PLAYER
PID 1305
PL 1505
Operating
Instructions
8FS 20-BIT DLC
OE
DIGITAL AUDIO
PD-T305
PD-T505
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of con-
necting and operating the unit is the same.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Austra-
lian models are not provided with this switch.
Mains voltages in Saudi Arabia are 127V and 220V
only. Never use this model with 110V setting in
WARNING:ro prevent FIRE OR SHOCK HAZ-
ARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep it in a secure area. This is for your
security.
[For Canadian model]
CAUTION:10 prevent ELECTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION: pour prevenir Les cHocs
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
"This product complies with the Radio interference require-
ments of the EC (European Community) Directive 87/308/EEC."
Saudi Arabia.
The line voltage selector switch is located on the rear
panel of this player. Before your player is shipped from
the factory, the switch is set to the power require-
ments of the player's destination. Check that it is set
properly before plugging the power cord into the out-
let. If the voltage is not properly set or if you move
to an area where the voltage requirements differ, ad
just the selector switch as follows:
e Use a medium-sized (flat-blade) screwdriver. Insert
the tip of the screwdriver into the groove of the
selector switch and turn it so that the power vol-
tage marking of your area points to the arrow.
VOLTAGE SELECTOR
@Q PIONEER'
The future of sound and vision.