Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised Service
Agent for installation of your product.
C
Preparation of location and elec-
trical installation for the product
is under customer's responsibility.
B
Installation and electrical con-
nections must be carried out by a
qualified personnel.
A
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products will cause
risks for your safety.
3.1 Appropriate installation
location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs and cupboard plinths.
• Do not place your product on a long pile
rug or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure that the
rear wall of it does not touch anywhere
(tap, socket, etc.) and also pay attention
to install the product at a place where it
will stay permanently.
B
Do not place the product on top of
the power cable.
• Keep at least 1.5 cm distance to walls of
other furniture.
• The rear surface of the tumble dryer shall
be placed against a wall
Dryer / User Manual
3.2 Ventilation hose and
connection (for products
equipped with an outlet vent)
Ventilation hose assures exhausting of the
air from inside the machine.
Vented dryer has 1 air outlet.
Stainless sheet metal or aluminum pipes can
be used instead of the hose. The diameter of
the pipe to be used should be minimum 10
cm.
Maximum hose and pipe lengths are given in
the table below.
Maximum length
1 elbow 45°
1 elbow 90°
1 elbow 90° short
1 wall passage
C
Each elbow and other passages
should be subtracted from the
above maximum length.
To connect a ventilation hose;
1. Connect the air outlet hose to the hose
spacer piece by turning it anti-clockwise.
2. Make the hose passages as shown below.
C
Exhaust of humid air from the
dryer into the room is inconve-
nient. It may damage the walls
and furniture in the room.
C
The ventilation hose can be rout-
ed outdoors via a window or it can
be connected to an air outlet in
the wall (see diagram below).
C
Air outlet hose must be extended
directly to the outdoors. There
must be a small number of elbows
as not to hinder air ventilation.
C
To prevent water accumulation in
the hose, make sure that it is not
folded on the floor.
Hose
Pipe
4 m
5 m
-1.0 m
-0.3 m
-1.8 m
-0.6 m
-2.7 m
-2.0 m
-2.0 m
13
Advertisement
Table of Contents
