Using Your Vacuum; Above Floor Cleaning - Bissell 3125W Series Manual

Using Your Vacuum

For additional ways to use your vacuum's features, check out support.BISSELL.com.
1.
Turn power ON. Turn
the brush roll on for carpet
cleaning and the switch will
illuminate. Turn the brush roll
off when vacuuming hard or
delicate surfaces.

Above Floor Cleaning

Visit support.BISSELL.com to see all the ways you can use your vacuum's tools.
1.
Push the Lift-Off® Release
Button and lift up to remove
the pod from the foot.
4.
Use the carry handle to
bring the Lift-Off® Pod to
hard-to-clean places in your
home.
WARNING
4 BISSELL.com
2.
Step gently on base and pull
the handle back to recline.
Note: The brush roll
automatically shuts off when
vacuum is locked in upright
position. Recline to reactivate.
2.
For the most reach, use
the Quick Release Extension
Wand. Push the release button
to remove.
To clean without the the
wand, twist circular hose cuff
counter-clockwise and remove.
5.
Replace the wand by sliding
into place until you hear a
"click". Reattach hose to
handle if needed.
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.
3.
Use the carpet type control
for optimized cleaning on high
pile and low pile carpet. The
control can be moved to the
middle position for medium
pile carpeting.
3.
Attach desired tool.
Note: For optimal use, attach
the Pet TurboEraser® Tool
directly to the hose instead
of the handle.
6.
Place the pod back onto
the foot.